Save To Worklist

MECH 325 Mechanical Design I

Introduction to manufacturing operations. Design for manufacturing and assembly. Design and selection of shafts, bearings, springs, seals and packing, and couplings. Design of bolted joints and power screws. Design and selection of gears, gear trains, brakes and clutches.

This course is not eligible for Credit/D/Fail grading.

Credits: 4

Pre-reqs: One of MECH 223, MECH 260.

Co-reqs: MECH 360 and one of MECH 328, ENPH 253, IGEN 330.


Status Section Activity Term Interval Days Start Time End Time Comments
STT MECH 325 101 Lecture 1 Tue Thu 9:30 11:00

Associated with tutorial sections T1A, T1B, T1E.

STT MECH 325 T1A Tutorial 1 Tue Thu 11:00 12:30
STT MECH 325 T1B Tutorial 1 Tue Thu 15:30 17:00
Restricted MECH 325 T1E Tutorial 1 Mon Wed 9:00 10:30
Restricted MECH 325 102 Lecture 1 Tue Thu 11:00 12:30

Associated with T1C, T1D, T1F.

STT MECH 325 T1C Tutorial 1 Tue Thu 14:00 15:30
Full MECH 325 T1D Tutorial 1 Tue Thu 17:00 18:30
Restricted MECH 325 T1F Tutorial 1 Tue Thu 9:30 11:00